1. Forum
  2. Fidonet
  3. ARROWBRIDGE

  • Arrowbridge II nodes.

    From Joseph Larsen@1:2320/100 to All on Fri Jun 3 09:35:02 2016
    Hi all,

    I can only seem to get 2 working nodes with Arrowbridge II. Anyone else have this problem?

    Thanks,

    |09ignatius |07(|15cia|07)

    --- DayDream BBS/UNIX (Linux) 2.15a
    # Origin: catch22bbs.com >>> >> > (1:340/800)
    # Origin: LiveWire BBS -=*=- telnet://livewirebbs.com (1:2320/100)
    * Origin: LiveWire BBS - Synchronet - LiveWireBBS.com (1:2320/100)
  • From Mark Lewis@1:2320/100 to Joseph Larsen on Fri Jul 1 11:32:02 2016
    I can only seem to get 2 working nodes with Arrowbridge II. Anyone
    else have this problem?

    did you ever figure this out? AFAIK my ABII is running fine on all my nodes... i think i'm using DOOR.SYS and somewhere i apparently defined each of my nodes for the specific port and irq or FOSSIL they are to use...

    )\/(ark

    Always Mount a Scratch Monkey

    ... HOOTERS: Delightfully tacky yet unrefined.
    ---
    # Origin: (1:3634/12.73)
    # Origin: LiveWire BBS -=*=- telnet://livewirebbs.com (1:2320/100)
    * Origin: LiveWire BBS - Synchronet - LiveWireBBS.com (1:2320/100)
  • From Mark Lewis@1:2320/100 to Joseph Larsen on Fri Jul 1 21:42:02 2016
    did you ever figure this out? AFAIK my ABII is running fine on all my n

    Yeah. I figured it out. This had to do with my Impulse setup. On nodes
    3 and 4, the COM port was set to 0. I set it to 1. To match the $_com1
    = "virtual" in the dosemu.conf file for Impulse.

    there ya go :)

    Thanks,

    welcome for the little i did ;)

    )\/(ark

    Always Mount a Scratch Monkey

    ... My wife ran away with my best friend and I sure miss him.
    ---
    # Origin: (1:3634/12.73)
    # Origin: LiveWire BBS -=*=- telnet://livewirebbs.com (1:2320/100)
    * Origin: LiveWire BBS - Synchronet - LiveWireBBS.com (1:2320/100)
  • From Joseph Larsen@1:2320/100 to Mark Lewis on Fri Jul 1 23:25:02 2016
    did you ever figure this out? AFAIK my ABII is running fine on all my n


    Yeah. I figured it out. This had to do with my Impulse setup. On nodes 3 and
    4, the COM port was set to 0. I set it to 1. To match the $_com1 = "virtual"
    in the dosemu.conf file for Impulse.

    Thanks,

    |09ignatius |07(|15cia|07)

    --- DayDream BBS/UNIX (Linux) 2.15a
    # Origin: catch22bbs.com >>> >> > (1:340/800)
    # Origin: LiveWire BBS -=*=- telnet://livewirebbs.com (1:2320/100)
    * Origin: LiveWire BBS - Synchronet - LiveWireBBS.com (1:2320/100)